|
STANDARD FEATURES |
| |
|
• |
Outdoor condenser
section |
|
• |
STAINLESS STEEL brazed plate evaporator with
1/2" |
|
|
insulation, and secured in a steel bracket |
|
• |
Hermetic compressor with crankcase heater |
|
• |
Suction accumulator |
|
• |
Water flow switch |
|
• |
Hot gas by-pass capacity control |
|
• |
On/Off switch for control circuit operation |
|
• |
Manual compressor lead lag switch on dual circuit units |
|
• |
24V control transformer |
|
• |
Return fluid sensing thermostat |
|
• |
High pressure refrigerant control |
|
• |
Low pressure refrigerant control with time delay |
|
• |
LED 24v thermometers on water inlet / outlet |
|
• |
Compressor motor contactor |
|
• |
Compressor and control circuit fusing |
|
• |
Compressor and hot gas valve time delays |
|
• |
"Hard start kit" (single phase units only) |
|
• |
Painted galvanized sheet metal cabinet |
|
• |
Refrigerant discharge / liquid access valves |
|
• |
1/2" insulation on all water and refrigerant lines |
|
• |
Liquid line drier, sight-glass, solenoid, TEV |
|
• |
Full refrigerant charge from factory |
|
• |
Computerized factory run test under load conditions |
